Tilt-Pac Sash Replacement Systems

Removing the Sash

Raise the bottom sash about 3". Depress vinyl jamb liner and ease top of sash toward you to a horizontal position. Lift one side and remove sash.

Remove the top sash. Lower top sash about half way. Depress vinyl jamb liner and ease top of sash toward you to a horizontal position. Lift one side and remove.

Replacing the Sash

The top sash must be installed first in the outside track (closest to the exterior).

CAUTION: When replacing sash, both sash pins must be positioned above the locking terminal assembly located in the vinyl jamb liner.

Hold the top sash in a horizontal position. Place one sash pin above the locking terminal assembly. Raise opposite side and place sash pin above locking terminal assembly on that side. Tilt sash up and, depressing the vinyl jamb liner, ease into place. Lower sash slightly to engage locking terminal assembly. Raise the top sash to top of frame and repeat the procedure for the bottom sash.

After the sash is installed, check the vinyl weather strip flange on the exterior side of the vinyl jamb liner to see that it is not wedged between the blindstop. (Older style vinyl jamb liners do not have the weatherstrip flange.) If it is, loosen it by sliding your finger along the blindstop.

FEED

In urgent need of Thanksgiving décor? Check out these gorgeous decorating ideas...

In urgent need of Thanksgiving décor? Check out these gorgeous decorating ideas from Country Living Magazine and get inspired: http://bit.ly/11sTCG9


23 Festive Thanksgiving Decor ...